diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
index f652b0c384ced4f1a2ed9cc6eeb1f7abb99669c7..c3a7be6615c547a5001c67996e18458b7f8e5b5d 100644
--- a/Documentation/devicetree/bindings/net/stmmac.txt
+++ b/Documentation/devicetree/bindings/net/stmmac.txt
@@ -7,9 +7,12 @@ Required properties:
 - interrupt-parent: Should be the phandle for the interrupt controller
   that services interrupts for this device
 - interrupts: Should contain the STMMAC interrupts
-- interrupt-names: Should contain the interrupt names "macirq"
-  "eth_wake_irq" if this interrupt is supported in the "interrupts"
-  property
+- interrupt-names: Should contain a list of interrupt names corresponding to
+	the interrupts in the interrupts property, if available.
+	Valid interrupt names are:
+  - "macirq" (combined signal for various interrupt events)
+  - "eth_wake_irq" (the interrupt to manage the remote wake-up packet detection)
+  - "eth_lpi" (the interrupt that occurs when Tx or Rx enters/exits LPI state)
 - phy-mode: See ethernet.txt file in the same directory.
 - snps,reset-gpio 	gpio number for phy reset.
 - snps,reset-active-low boolean flag to indicate if phy reset is active low.
@@ -152,8 +155,8 @@ Examples:
 		compatible = "st,spear600-gmac";
 		reg = <0xe0800000 0x8000>;
 		interrupt-parent = <&vic1>;
-		interrupts = <24 23>;
-		interrupt-names = "macirq", "eth_wake_irq";
+		interrupts = <24 23 22>;
+		interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
 		mac-address = [000000000000]; /* Filled in by U-Boot */
 		max-frame-size = <3800>;
 		phy-mode = "gmii";